Print this page

Stanimir Dimitrov Iliev

NanoERA Bilateral Seminar

20-25 August 2012: NanoERA Bilateral Seminar at IMech-BAS and University "Prof. A. Zlatarov" Burgas

FP7 - INCO.2010-6.1 - 266529 BY - NanoERA

"Institutional Development of Applied Nanoelectromagnetics:

Belarus in ERA Widening"

NanoERA Bilateral Seminar

at IMech-BAS and University "Prof. A. Zlatarov" Burgas

20-25 August 2012



20 August  2012

Scientific Seminar at IMech-BAS, Sofia, Block 4, Room 200

9:45 - 10:00     Registration

10:00 - 10:15    Opening

10:15 - 10:30    Overview of objectives and activities of NanoERA project

Sergey Maksimenko - project coordinator

10:30 - 11:00    Challenges and perspectives of nanoelectromagnetics

Sergey Maksimenko, Gregory Slepyan - Belarus State University

11:00 -11:30   Electromagnetic properties of polymer composites filled with different nanocarbon inclusions in microwave frequency range

Polina Kuzhir et al. - Belarus State University

11:30 - 12:00 Nanomechanical properties and profiling of different materials using nanoindentation

tester equiped with AFM and 3D Profilometer

Evgeni Ivanov - OLEM, Institute of Mechanics-BAS

12:00-14:00 Lunch

14:00 - 14:30  The first observation of antenna resonance in thin single-wall carbone

nanotube films.

M.V.Shuba, A.G.Paddubskaya, P.P.Kuzhir, S.A.Maksimenko, et al.

Belarus State University

14:30-15:00     Effective non-distractive cutting of single-wall carbon nanotubes

M.V. Shuba, A.G. Paddubskaya, P.P. Kuzhir, S.A. Maksimenko, et al.

Belarus State University

15:00 - 15:30  Macro and micromechanical and tribological properties of different materials

I.Borovanska - Institute of Mechanics, Bulgarian Academy of Sciences

15:30-16:30    Round Table Discussion "Bilateral Collaboration between the Institute of

Mechanics - BAS and the Institute for Nuclear Problems - Belarus State

University within the NanoERA project"


21-22 August

Visit at Open Laboratory of Experimental Micro and NanoMechanics (OLEM), Block 4

Demonstration of the equipment and tests, available in OLEM:

  • Macromechanical testing with UMT-2 (CETR, USA). Stress-strain tests in different modes (e.g. tensile, twist, three-point bending, compression, etc.), creep and relaxation.
  • Micromechanical testing with UMT-2 (CETR, USA). Tribology: friction and wear, coefficient of friction. Microscratch. Microindentation.
  • Nanomechanical testing with UNMT (CETR, USA) and AFM. Nanoindentation with Berkovich indenter. Scanning with AFM of the nanoindentation imprint.
  • Nanostructure - Scanning of the surface with Atomic Force Microscopy.
  • 2D and 3D profiling of the surfaces. 3D topography for quantitative and qualitative determination of roughness of the surfaces. 2D and 3D scanning and topography of the profile of the imprint after scratch, friction and microindentation test.
  • Rheological and DMTA investigations with AR-G2 rheometer  (TA Instruments).

Selected experiments with samples provided by the partners from the Institute for Nuclear Problems - Belarus State University.

23-25 August

Presentation of NanoERA project at the University "Prof. Asen Zlatarov", Burgas

Seminar with selected presentations

Round Table Discussion

Visit in the University "Prof. Asen Zlatarov"



Participation in the Seminar at IMech-is free of charge



Prof. Rumiana Kotsilkova -    Tel. 979-6462,    e-mail:

Assoc. Prof. Evgeni Ivanov -  Tel. 979-2479,    e-mail:


Modified date:27-04-2024